You typically store cartridges when you want to use a different ink set (and therefore different cartridges) and need to store the existing cartridges for future use. This procedure explains how to remove, store and reuse cartridges. Following this procedure will extend the life of your cartridges and prevent ink from leaking from the cartridges.

Note: If you lay down a cartridge with ink in it, lay it on its front side so that the flex contacts face up. This prevents ink from leaking out either the top opening or out the jet area on the bottom. Do not touch the flex contact area of the cartridge.

To remove and store cartridges

1. On the printer control panel, press Utility Menu then Access Cartridge. This moves the carriage away from the service station and enables you to easily remove the cartridges.

2. Disconnect the cartridge tube from the carriage by pushing down on the disconnect button and removing the quick connect fitting.

3. Remove the cartridge from the carriage by gently pulling the top edge toward you, then lifting it out of the carriage. Do not remove the cartridge tube from the cartridge. Leaving the tube fitting attached to the cartridge will maintain the negative pressure inside the cartridge that is required for proper operation. It also prevents the cartridge from leaking.

4. Wipe any ink from the quick connect fitting at the end of the tube using a lint-free cloth.

5. Insert the cartridge into the cartridge garage. Make sure that the cartridge cap lip snaps and locks into the cartridge locking tab. This will assure a good seal.